Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a CBS350 switch that is set up to do inter-VLAN routing and provide DHCP addresses. That has been working without any issues for quite a while. Recently, I have created a private VLAN on it which is working okay except for one issue. I cannot ...
You probably missed this in my message."put a router on a promiscuous port"I guess that's my fault, because if you put a router on a promiscuous port, there is no inter-VLAN routing there. It's all the same subnet.
CISCO advises to update mesh extenders first and I would take this advice.Have you tried to use a different browser? Is the image file in the local file system?
C1300 switches are picky about SFP modules. I have 3rd-party SFP modules that work when connecting two CBS350 switches, one C1300 and one CBS350 switches, but they do not work when connecting two C1300 switches.
Blinking green is fine. It means a configuration is applied to an AP. However, if it goes back to white, it's not a good sign since white shows up right after a POE cable is connected. I suspect some POE issue.
