Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
The router crashes due to below error -
System returned to ROM by bus error at PC 0x25496778, address 0x26C
Router crashes only once and now its working fine.
It must have been the software error due to which is happened. No hardware failure or ...
The glbp got disabled on both groups and couldnt find the reason for this.
Logs from the router -
018895: Aug 9 01:11:15.731 mumbai: %GLBP-6-FWDSTATECHANGE: GigabitEthernet0/0 Grp 10 Fwd 2 state Active -> Disabled018896: Aug 9 01:11:15.731 mumbai: %G...
Is 802.1x supported on cisco 2911 router ?
I want to run below commands -
Router(config)# radius-server local
Router(config-radsrv)# nas ip-address key shared-key
But these commands are not supported in the router.
Router image - "flash0:c2900-univ...
Hi,
All the AP's connected to this WLC AIR-CT2504-K9 went down and again came up without any reason.
The only reason is could see is 'Reason: Capwap WTP Event request'/'Reason: Capwap Echo request' . But this doesn't explain why all AP's got disconn...
Hi,
All the AP's connected to this WLC AIR-CT2504-K9 went down and again came up without any reason.
The only reason is could see is 'Reason: Capwap WTP Event request'/'Reason: Capwap Echo request' . But this doesn't explain why all AP's got disconn...
Hi Mark
The network was up and running on this configuration, but suddenly got this message alert(GLBP disabled).
Right now the network is fine but need to get to the cause why this alert was shown.
The only change made was IOS upgrade of the router....
Yes, they are in FlexConnect. We have 2 sites and all the AP's showed the flapping.
Also the UP time of WLC is 198 days , so this cant be the issue with the switch, right ?
Also from logs i couldn't find why exactly this happened.
Should I go with o...
