laukiknahar91
Level 1
Level 1
Member since ‎02-08-2016
‎08-18-2017

User Statistics

  • 11 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Discussion Posts
First Discussion
First Question
10 Discussion Posts
1 Reply

User Activity

Hi, The router crashes due to below error - System returned to ROM by bus error at PC 0x25496778, address 0x26C Router crashes only once and now its working fine. It must have been the software error due to which is happened. No hardware failure or ...
The glbp got disabled on both groups and couldnt find the reason for this. Logs from the router - 018895: Aug 9 01:11:15.731 mumbai: %GLBP-6-FWDSTATECHANGE: GigabitEthernet0/0 Grp 10 Fwd 2 state Active -> Disabled018896: Aug 9 01:11:15.731 mumbai: %G...
Is 802.1x supported on cisco 2911 router ? I want to run below commands - Router(config)# radius-server local Router(config-radsrv)# nas ip-address key shared-key But these commands are not supported in the router.  Router image - "flash0:c2900-univ...
Hi, All the AP's connected to this WLC AIR-CT2504-K9 went down and again came up without any reason. The only reason is could see is 'Reason: Capwap WTP Event request'/'Reason: Capwap Echo request' . But this doesn't explain why all AP's got disconn...
Hi, All the AP's connected to this WLC AIR-CT2504-K9 went down and again came up without any reason. The only reason is could see is 'Reason: Capwap WTP Event request'/'Reason: Capwap Echo request' . But this doesn't explain why all AP's got disconn...
Community Statistics
Member Since ‎02-08-2016 11:44 PM
Date Last Visited ‎08-18-2017 03:54 AM
Posts 11