Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would appreciate alot if someone could assist me in understanding the below vpn routes received at a PE.
I'm expecting all the terminology which are listed in the route shared, Many thanks in advance.
-----------------------------------------------...
Hi
Cisco 4G router drops out connection 2-3 times a day, when I check at the logs I found the below.
Please note: the Signal strength is good, however the link the drops.
Jun 22 00:06:39.662: %CELLWAN-2-BEARER_DELETED: Instance id=0, Default be...
Hi all,
Please help me to fix this problem, BGP hold time expires frequently even though the cellular link signal strength is very good. Also, why would that AFI error appears which makes the BGP session down.
Config of DMVPN hub and spoke has been...
Hello
Please help me to identify why the bellow script aborts, ,which is meant for power-cycling my router modem to get away from cellular interface going into dormant state even after getting a decent signal.
Config & logs:
.Mar 29 21:25:00.005: ...
Mr. Anand Singarayan Paradesi ,
The purpose of some commands in your commands are still unknown, like there is no Nat inside however there is Nat outside and no access list for 98 and all..
You need to share your exact motive fully of the custom...
Hi Vinit,
Still finding the same,
*Jun 1 13:48:10.037: %BGP-3-NOTIFICATION: received from neighbor 172.25.2.1 active 2/8 (no supported AFI/SAFI) 3 bytes 000000*Jun 1 13:48:10.037: %BGP-5-NBR_RESET: Neighbor 172.25.2.1 active reset (BGP Notification...
Hi Vinit
Here is the update, I've configured it on 25th May with below commands and errors did appeared in the timelines as mentioned below.
Please share your Comment, thanks.
m-quest-qld-tingalpa-r02#sh run int tu100 | i mtu|tcp ip mtu 1400 ip tcp...
Hi vinit
I've tried putting ip mtu 1400 on both tu100 and tu200 interface in 2 devices, however 1 of the devices did generated holdtime expiry error and session dropped.
The other one works fine still, any particular reason to use 1400?
Also, I've u...
Hi
I'm not sure if AFI=2 in BGP is due to that, however I shall update that command tomorrow after seeing how the IP MTU 1400 command works in fixing the holdtime issue.
Thanks, Ramesh.
