hello guys, I would like to ask if it is normal that the SFP-10G-T-X module installed on a slot of the C9600 is seen as SFP-10GBase-SR.Is it possible that it is an update problem?Thanks for the answers.
I understand that until everything works it is better not to touch anything.In fact the module works well although it is seen by the switch as a 10G-sr module.Ok I accept the advice.
The 9600 firmware is 17.03.04 on SUP 1 card type.As DanielP211 said, i think it's a small bug. I'll try to update the firmware.Thanks everyone for the suggestions
the modules are original cisco. Below is the output of the show idprom interface command. You can view that the Transceiver Type and Product Identifier (PID) are different. Why???IDPROM for transceiver TwentyFiveGigE1/0/43:Description = SFP or SFP+ o...
