Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Anyone has configured successfully 3G/HSPA using Cisco 1841 HWIC-3G-HSPA to NTT Docomo network.There is no username/password required.APN: mopera.flat.foma.ne.jpBelow is my partial config. My cellular interface keeps reset between UP and Down status....
The switch drop to rommon mode with the following errors:Failed to get configurationInvalid parameter block -- no mac address available.Xmodem file system is available.switch: flash_initInitializing Flash......no flash filesystems found.switch: dirLi...
I have a Guest/DMZ WLC terminating EoIP tunnel. After the user is authenticated by Web Auth, only HTTP/HTTPS traffic is required to redirect to Bluecoat Proxy for filtering.The Bluecoat Proxy and DMZ WLC wireless guest users are located in different ...
I have a 2811 with the following:- HWIC-4ESW + ILPM-4 - 2811 power supply with black IP Phone icon (Inline power support)- IOS 2800 adv ent 124-22TI cannot issue "show power" command and my HWIC with the inline daughter card installed does not supply...
Anchor WLC redundancy is achieved through the mobility groups. For redundancy, we can increase the mobility group size, including additional controllers for redundancy.Does N+1 redundancy works across different mobility groups (Anchor WLCs in differe...
I got it working and want to share with the community here.Step 1: Create a GSM Profile for NTT DocomoStep 2: Create a Chat ScriptStep 3: Config the routerStep 4: VerificationSidenote: NTT requires PPP CHAP authentication response with a "dummy" pass...
What is the purpose of entering "i" if all the above methods failed? I tried and it gives me "Unknown cmd: i"The switch fails to see any flash device and looks like it was gone from the filesystem.
Hi Peter,There was a similar post a couple of weeks back. I have no idea how this happened.Rgds.By Sam Chang under Cisco Community forum: Upgrade IOS Problem for C2960There are three 2960 took this problem:WS-C2960-48TC-S 12.2(25) 2WS-C2960-24TC-S 1...
Thanks fella5.Your explanation is very clear and with the step-by-step config guide below, the setup is working as expected.http://www.cisco.com/en/US/docs/solutions/Enterprise/Mobility/emob41dg/ch10GuAc.htmlCheers
