Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,recently I faced a problem when we launched HP OV monitoring system. It is required to ping all enabled interfaces on ASA. "Inside" interface is monitored well but "Outside" is unavailable by ICMP and due to this alarm generated. I know that...
Dear colleagues, I have a problem with integration Cisco Unity Connection 2.1 with Cisco Unified CM 6.1 . I followed article http://www.cisco.com/en/US/docs/voice_ip_comm/connection/2x/integration/cucmbe/guide/cucintcucmbe.html#wp1022253 but couldn't...
Dear Cisco Support. I have CW with LMS 3.1 and RME 4.2. Last week I've added 10 devices in CS. In 3 days in RME that devices still were showed as unknown (blue box with question mark). I ran Checking Device Credentials job. The job was failed with 'D...
Dear Cisco specialists,could you help me with recovering 1310 access point? Yesterday I tried to download IOS via console and decided to change speed on console to speed up the process. I put 'set BAUD 115200' in rommon mode and after this lost comun...
Dear, all. We had crashed one of our hard disk on server last weekend. On this disk CiscoWorks was installed. Now after fixing and recovering from backup the software works but there is an issue with authorization. First of all when Home page of Comm...
Case closed. The problem was that CW tried to communicate with devices using wrong community. Why and how it was changed in Default Profile we will find out. Thanks to all for supporting.
ericgarnel, I tried all standart speeds (110, 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200. On 230400 HypertTerminal couldn't open serial port). On each speed there were something like "þŒþÎþ}ü}ü|ü~ ppppþpx óþpüþpxü|ü pËÃ...
