About linz cyber security

linz cyber security · 07-18-2022

Hi, I am doing a school project and I have been trying to figure out how to configure OSPF to prefer the direct path between Area 1 and 2 (that is, the path between Router 3 and Router 5), in the diagram attached to this post. Can anyone guide me ac...

linz cyber security · 07-18-2022

thanks much will make the changes and let you know when I am successful. Thanks for guiding me in the right direction.

linz cyber security · 07-18-2022

thanks much will make the changes and let you know when I am successful. Thanks for guiding me in the right direction.

linz cyber security · 07-18-2022

So let me be sure I understand what you are saying. In R3 and R5 I need to set the cost manually to be lower than that of R4? And that this is done by entering the following commands into the CLI on both routers: inter xip ospf cost x One final quest...

Member Since	‎07-18-2022 05:17 PM
Date Last Visited	‎07-20-2022 12:01 AM
Posts	4
Total Helpful Votes Received	20

User Statistics

User Activity

OSPF Path Selection in Area 0

Re: OSPF Path Selection in Area 0

Re: OSPF Path Selection in Area 0

Re: OSPF Path Selection in Area 0