Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been trying to get some SPA5xx phones running 7.5.7 to have a longer dial plan timeout and not getting anywhere.
The main dialplan base dialplan we have is [*x].
I have tried
P10 | ([*x].)
(P10 | ([*x].)
P10, ([*x].)
and various adjustments to t...
Been working off and on with some customers that require "key system emulation" and while we are able to get Shared Line Appearance to work just fine, with multiple lines on the phone the behavior can become quite erratic.Right now it will in some ca...
Sorry to bring out the dead, but have there been any updates or additions to this list?With Verisign selling to Symantec then to Broadcom the possibly to Digicert(?) and Cisco ending their CA per Field Notice: FN74094 , I'm hoping the only option lef...
Dial tone, e.g. the 350@-19,440@-19;20(*/0/1+2) tone that plays when you pick up the handset. The phone with a [*x]. dial plan plays this tone for approximately 3 seconds before timing out the call.
What I am looking for is to increase the initial delay after lifting the reciever/activating headset/activating speaker phone and when the first number is pressed. Right now it times out after ~3 seconds.
Very Strange, according to section 8 of the Administration Guide, P is the Dial Plan Timer (Off-Hook Timer) which controls the amount of time for off hook. There's even an example for it being used to increase the timeout.
I can increase the Short Ti...
