Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
username <user1> privilege 15 password 7 <ENCRYPTED>!line con 0login authentication console!aaa authentication login console local Can someone explain why user is not given privilege 15 access when he consoles in?Is there any command to check privile...
On R1int vlan 2, ip add 10.1.1.1/30int fa0/0, switchport mode access, switchport access vlan 2On R2Int fa0/1Vrf-Testip add 10.1.1.2/30Can R1 and R2 ping each other?Does the vrf or the vlan takes precedence?
In the ACL list 10 permit icmp 10.0.0.0/8 host y.y.y.yThe above line does not work UNLESS I use a more specific subnet which in this case is 10.1.1.0/24.So I have to put the line below. 10 permit icmp 10.1.1.0/24 host y.y.y.yCan someone explain to m...
I have 1 router in which there is 1 physical interface with ipsec tunnel to another site.I want to have another router for redundancy.What is a possible design?
I don't quite get the difference between authentication and authorization.Why was authentication initially used for username admin then later authorization was added?
Well I want to understand. Ssh was not configured with privilege 15. But my username was configured with privilege 15, so why did it not get privilege 15?
This means some services in a VLAN,eg.pppoe and brigde-group not be configured on a single subinterface,that is so inneccesary. I don't understand this sentences
