About doridor

doridor · 06-27-2023

I am trying to increase the MTU of my L3out routed ports to 9216,when I increased the MTU on one of the ports and pinged it form the other side with a 9216 byte icmp packet, it received the request and responded with a 1500 byte icmp reply. And once ...

doridor · 05-10-2023

I am trying to monitor CPU utilization in comparison to the CoPP statistics. The CoPP statistics are different for each module, and I noticed that when querying my switch for the CPU cpmCPUTotal1minRev OID, each entry is associated with a different m...

doridor · 05-07-2023

I want to monitor packet drops on the default Control Plane Policy but I can't find an OID for the control-plane policy map.Does anyone have it? Thanks in advance

doridor · 03-16-2023

Hi everyone, I am trying to Deploy a service graph that will load balance traffic to a certain EPG between to proxies.The traffic to the EPG is redirected to the proxies, but the problem is that it arrives with the destination address of the EPG endp...

doridor · 01-04-2023

Hello Everyone,I am in the process of wiping my ACI fabric, to do so I removed all of the leaves and spines from the fabric using "remove from controller" and wiped all of the APICs using acidiag clean,setup,reboot.I now want to wipe all of the switc...

doridor · 06-28-2023

The problem isn’t with the device i am trying to reach. The routed port on the border leaf will not even sent the packets if they are larger then 1500 and the df flag is set

doridor · 03-26-2023

Bumping the question again,I solved the issue by creating a dummy interface (along side the physical interface) on the proxies, with the destination address of the EPG endpoint, so the proxy doesn't discard the packets. I don't like this fix so if an...

doridor · 01-04-2023

@Robert Burns Thanks A lot Robert, Unfortunately I have to use a console connection but I now know how to avoid the issue for next time.

doridor · 01-04-2023

@Robert Burns I still couldn't login , I did see a slight difference when trying to log in with rescue-user. I don't know if this an indication of anything but I thought I'd give it a try.when logging in with rescue-user the prompt that is returned i...

doridor · 12-11-2022

Never Mind I found the answer, I need to use to community Policies. One for the global scope and one for the VRF context.@anirukasthank you for all the help

Member Since	‎07-28-2022 12:38 AM
Date Last Visited	‎09-18-2023 01:39 AM
Posts	21
Total Helpful Votes Received	7

User Statistics

User Activity

L3 out interface with MTU 9216 wont send packets larger the 1500 bytes

Handling of Control Plane Traffic For Different Modules

SNMP Oid for the default CoPP in NXOS

Load Balancing Traffic Between Load Balancers Using Symmetric PBR

Issue Logging In to Nodes After They Were Removed From The APIC

Re: L3 out interface with MTU 9216 wont send packets larger the 1500 b

Re: Load Balancing Traffic Between Load Balancers Using Symmetric PBR

Re: Issue Logging In to Nodes After They Were Removed From The APIC

Re: Issue Logging In to Nodes After They Were Removed From The APIC

Re: Leaves Don't Return Requested OIDs