Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I was using PCI352 in linux system (kernel driver) with no problems for a long time. For about a week, I have seen in many stations the error message:BAP setup error. Too many retries.Is there any security issue related to this product ? I hav...
Hi,My WGB350 is showing the following message:"0:01:10 S Unable to determine radio type !"It allways happens a few minutes after power on the radio. I updated the firmware to 8.85 but the same problem persists.When it happens, the telnet header shows...
I've tested Linksys WAP11 connecting to BR-350 and works fine, but not with AP350.Is there any configuration options in AP350 that may allow generic 802.11 connections ?I tried (no aironet extensions + bcast essid).Luciano Lima.
Hi,I have a 24 port 2950 switch. One of the used ports sometimes blinks between orange and green (when stats mode is set).Could any one tell me what does it indicates ?Thanks,Luciano
Now CEF is enabled.I could not see any betterment. The processor is about 50% busy. But it's OK.There is about 2200 pac/sec in the fastethernet interface. Sometimes it is 3500 pac/sec.Is there any practical limit in pac/sec using a 2600 router ? Th...
