Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,Just looking for a bit of advise on an issue that has started to show up on a set of ACE10-6500-K9 blades we have installed.The ACE's is running Version 3.0(0)A1(6.1).They have been up and running for about 18 months now with no issues at all, the...
Hi All, Has anybody got a URL that they can share that has the release notes on for the differant versions of the software that are being released for the for th ACE blade.I have done a search on CCO but have not been able to find them.Also if poss a...
Hi All,Does any body know if you are able to load IBM Director on to IBM Sevrers running an IPCC with out issue's.?Has anybody out there got IBM Director installed on IBM Servers running IPCC without any issue's.?CheersTim
hello all,I have a problem with num-exp. The num-exp part works fine and route the incoming call correctly. The problem is that on the IP Phone the number showing that the incoming call is from is the number they dial that gets convert in the num-exp...
Hi No seen it on an 8831 but did see the same message on a 7965, found the patch lead was faulty, plus structured cabling back the switch port. Both swapped and work OK after that. Have you tried plugging in a 7965 to see if that works, ie one that y...
HI,We just some of these delivered and had some issue pairing the mic's up to start with, but they now pair ok.So what I did was this.Charge the MIC'sThen remove from charging base unit.Go in to the paring menu on the 8831 and start the pairing off f...
HiI have attached a file with which shows the command run during the issue, and you can see the issue.Also the 'show serverfarm MABBCLIVESF detail' was run at the time, output in the file, also run that command to today and added the output.I am seei...
Hi, Have had the same problem with a couple of 7935's after an upgrade of the code, it corrupted the admin password and was unable to acces the phone config, found a bug ID listed on cisco ( can not remeber ID off top of my head ) but you need to do ...
