Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I fell in love with the Cisco SG300 series - great small switch, L3 switching, amazing price point...UNTIL I found out there was a TCAM limitation of 400-500 hosts (depending on other features such as ACLs, static routes, etc...). OUCH. This little u...
Okay ASA Superstars - here's my dillema.I'm working on a site with a 100Mbps Internet connection which regularly does real-time video streams for on-site classes. The site sustains an average 40-50Mbps active utilization. During idle times of the nig...
Hello -I just ran into an instance where a single user on a network completely maxxed out a 100Mbps Internet connection for 30 minutes downloading. I'd like to create a policy on the Cisco ASA that throttles bandwidth per user. In a nutshell, I would...
Hello,We are converting our environment from a traditional T1 (POTS) incoming phone line to a SIP trunk on our Cisco UC520. DID numbers are configured on each circuit (DID on T1 provisioned and works fine, DID on SIP Trunk provisioned). A quick diagr...
Hello -Does anyone know if there is a way to configure a CME router as a hub/proxy for RTP? Currently, the IP Phones set up calls using Skinny (managed by the CME router), then the RTP stream is set up between the phones directly (by design). Instead...
I had thought about doing it that way...which is what prompted this post - a 255 item access-list simply to define per-user bandwidht limits? There's got to be a better way......right? If not, how do ya'll prevent a single user from jeopordizing the ...
Bruno -I needed your second command there too (no supplementary-service sip refer)! After Paolo's submission, the AutoAttendant answered, but could not perform a dial-by-name transfer. Thanks again!Jeremy
