Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
asa(config)# crypto ikev1 policy 10
Usage: crypto { ca | dynamic-map | ikev1 | ikev2 | ipsec | isakmp | key | map }
For more detailed help, please refer directly to the subcommands with ASDM I get the same message.I know nothing on this wor...
why do I get that error, even when never IKEv2 has been used or enabled in a L2L config?on 4 identically configured asas, I only get that error on 1 device, and so the tunnel doesn't come up.thx for tippsDN
hi,I have 4 branch-offices connected via L2L to the main office (all 5505, 8.4.3)When I compare the running configs, they look very similar, and so they should, because the branch-asas are all configured identically (internal IPs are different, outsi...
as you can see in the code-block, the asa replies the first line with a hint, that the entry is wrong. But in fact, it's not. And of course the older syntax cannot work, too.So I cannot even start with something, whencrypto ikev1 policy 10throws an e...
This is not funny, Cisco.You declare yourself as a market leader, at least a link to a working video should be possible, when Cisco already removes wizards... Publish the video in yt, and we all can see it - as we don't have to use some extra complic...
you know this is bull**bleep**!?When it switches from E to A after firmware upgrade, you cannot do anything but open an RMA.Makes me angry, this proof of incompetence from the devs. Just check a firmware PRIOR releasing it would be helpful, not?And c...
I bought 3 WAP 371 in Europe. All are backside labeled with "E" and V03.All 3 were E and V03 under management.After Firmware-Update to 1.3.0.7 of 1 of 3 devices shows it as "A" and V01.Tried to revert to 1.3.0.6, now it shows A and V01 but with firmw...
