Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, I try to get a basic policy created by using web categories to block (Like Pornography, hacking sites and alike) but I cannot find the option anywhere. This is a trial license and the licensing team advised there is no such extra license th...
Dear All, I am in need of your assistance... Thank you for all the replies in advance!I seem to have a rather unusual problem, we have an office with a 300/300 Mbps internet connection and about 50 users. I have checked what router would do the job w...
Dear All, anyone can help with the issue?I have read a lot and tried everything and nothing seems to solve the issue.I have a C2621 where with the default config (after reload no initial config taken) aftert an erase nvram.so the router is literally ...
Dear All,Recently my lab did grind my gears and I simply cannot figure it out why my frame-relay config wont work.This is the topology I use.R1 Uses a Multipoint S0/0.1 interface and OSPF works fine in the area with routers R2 and R3.R1:R1#sh frame-r...
Here is the scenario:When havin only the default VLAN everything works fine.when making a VLAN (Lets say 10) and choosing another switch for that VLAN as the Root Bridge (picture 4 the red line) it messes the whole network up.any ideas where to begin...
Adam, thanks for the reply, but I did find this also...http://anticisco.ru/pubs/ISR_G2_Perfomance.pdfhere table 1 suggests that a 890 is more than enough... confusion, confusion everywhere... I know, to be on the safe over-exaggerating with the 4000...
Dear Bilal,Thank you for the suggestuin, unfortunately I cannot enter the command ip dhcp client-id hex.I tried it via: int fa 0/0 mac-address xxxx.xxxx.xxxx ip address dhcpbut in such a case no debug output is shown, as nothing would happen...
Nothing seems to help... a 2620XM as dhcp server leases an address, a dlink, whatever leases an address. only the ISP and the ISP's modem not... however if I set it up as 192.168.1.1 255.255.255.252 and the router is the x.2 and than I have my own s...
Dear pdriver,thank you for the suggestion, sonds silly, I do not know if have tried it or not will definitely do and see if that makes a difference, but the point is good, thank you again!
