Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem that I am working on and wondering if somebody can help me out. We have dual 10 Mbps TLS circuits from our facility to another Regional office. I have configured floating static routes for the metro E; however, the problem with this ...
We have a situation last night where about 4 AP-350s (connected to a 3750) got rebooted all by themselves. AP log files only indicated SYS-CPUHOG messages.IOS: 12.3-7.JA. I know this information is probably not enough but any pointers provided would ...
We have a couple of Cisco 3750 switches, IOS version 12.2(25)SEC, that are currently running DHCP server and storing the database on a Windows FTP server.Is there a way to store that DHCP database locally in flash? It looks like"IP DHCP DATABASE url....
Hi, I am having a problem where several aironet 350 units have firmware issues when switched from VxWorks to Cisco using Cisco conversion tool. These units are basically non-operational now. I am wondering if there is a way to push the current firmwa...
I work for a large manufacturing plant that employes Cisco 3750 and 6500 series switches. We are having a problem in using 255.255.255.254 mask on point-to-point VLAN uplinks. Every time, the switch restarts, after the initial boot process, it locks ...
Hi,Even though I never attempted that but based on what I have studied, you can use Distribute-Lists to control what routes you want your routing protocol to adverstise. Will the following work?access-list 10 deny 0.0.0.0 0.0.0.0access-list 10 permit...
Thanks for replying.I do not get any error after entering the command. The file is created in flash but bindings are lost when the switch reloads. To me, it looks like the bindings exist only in NVRAM and not written to flash.We had a power outage re...
Thankyou for your reply but my issue is not reconfiguring the unit but reloading the firmware. Upon bootup,the unit goes into ROM mode and provides very limited commands.What I need to know is a way to reload the IOS????Haroon
Thankyou for your reply, Prashanth. Yesterday, I upgraded my IOS from 12.2(25).SEB to 12.2(25).SEC and it seems to have solved the problem.At startup, it still gives that error message but then returns to the prompt.All looks ok now.Thanks again for ...
