Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have an issue that I would like some advice on using the ACE 4700 appliance. i have a client side and server side VLANS confiured on our ACE appliance, so its confiured in routed mode.Client side VLAN is:interface vlan 9 description CLIENT ...
Hi,Can someone please explain whether i need "auto qos trust dscp" or auto qos trust cos" command on the ports that are connected to the switch. The WLC is configured to use LAG when connecting to the Cisco 6500 switch. The switchports are configured...
Hi - Use your IGP metrics to weight the routes so that all traffic goes to the primary hub and then to the backup hub should the primary fail. I have done this with OSPF and it works like a dream..
Hi Ziyad,
Yes you can have more than two hubs. To do this you will need to add additional statements on the spokes for the additional Hubs. This is common if you have for example two DC's and you wanted to have 2 Hub routers per DC.
So using Marwan...
Hi Marwan, Hope OTV is included in this forum, if not then no issues... I have deployed OTV across two datacentres using N7K's and have allowed a number of VLANS for systems that need to reside in the same VLAN across the DC's. We are now in the proc...
They can reside in the same VDC but you still cannot configure the F2e module as a layer 3...Just tried with F2e modules, F1 and M1 modules running 6.2.2 but you cannot configure layer 3. There is mention of proxy the traffic from the F2e module to t...
Hi Justin,Did you ever get this issue sorted out? I am about to configure the same and just wanted to check the correct way of doing this with N5K and Cisco 6509E as the L3 device doing all the routing..Any advice will be much appreciated..ThanksZee
