Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have Catalyst 9100AX series APs. We want to convert one of them to EWC. We tried to factoy reset both however after the reset they are still act like CAPWAP and stuck at CAPWAP States.P.S. We have WLCs in our network but we isolated the VLA...
Hello,I am using a Cisco 9800 WLC and want to configure 2 different guest ssids with different client vlans in a same AP.I created 2 policy profile and 1 policy tag. Added 2 policy and wlans this policy tag.I want to do that for site tag but site tag...
Hello,I configured a guest ssid with external radius on Meraki.I entered radius ip and take capture from radius side there is no authentication radius from Meraki.Any ideas?While troubleshooting the issue I realised that there is 2 different url for ...
Hello,I use a 9800 WLC on Esxi Server. WLC works fine i can do config via SSH.I tried to do config from VM console. I loged in the wlc and run enable command on exec mode but "% Error in Authentication" error occurred.Any idea for this issue?
Hello,I have Cisco 2500 with 8.5.103 version and a AIR-CAP1702I-E-K9 AP on it. I upgraded WLC to 8.5.182 with aes and ap bundle file but AP is stuck on the downloading state.I checked the logs on WLC :*spamApTask5: Mar 04 15:13:41.842: a8:9d:21:13:18...
Yes, I did and stuck at this step because after 20 sec press, there was no login prompt but only CAPWAP logs that I sent already. "The console session writes out how long the Mode/Reset button has been pressed for. At least 20 seconds are required fo...
