Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was curious if there is a way in radius to set a banner that can be used by ever network device through radius. Radius attribute or something. We have a new security officer in and instead of changing it on every system i would like to manage it c...
Anyone have any luck getting this to work? I am at this point just trying to get the radius set up and get the certificate pulled into the EAP section of NPS. Or know if Cisco supports this type of setup. My 2003 IAS box was a snap but now have the W...
All,New to Mars and starting to understand the framework. Has anyone had success looking for linkup link down just on Gig or portchannel links? Or looking for sup failovers to generate events to email? Also I am trying to see how I can look at the g...
I have a 3725 that is running Frame-Relay over ATM.The 3725 is an ABR between area0 and area3. The other side of the link is an 1841 which is also in area3.I have configured both links to ip ospf network point-to-point. Below is my configuration on b...
I was able to ping the OSPF multicast address of 224.0.0.5 and got this response on both ends. From 3725rtr#ping 224.0.0.5Type escape sequence to abort.Sending 1, 100-byte ICMP Echos to 224.0.0.5, timeout is 2 seconds:Reply to request 0 from 10.30.1....
Thanks for your response. I hardcoded the router-id and same issue. Here is the full error log. Router ID 1.1.1.9 is the 3725 and 1.1.1.162 is the 1841eb 4 14:06:00.206: OSPF: Rcv hello from 1.1.1.9 area 3 from Serial0/0/0.1 10.30.1.161Feb 4 14:06...
