Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My scenario is as follows;Site A - AS100Site B - AS200Site C - AS300Sites B and C are connected to site A via DS3. This is the prefeered route when the two sites need to pass data. Sites B and C are also directly connected via a T1 link. This is not ...
I have a number of routers (1700, 2600, 3640) that I manage in remote locations connected by Frame Relay links. I have no problem downloading or uploading either configs or images to any of my routers but the 3640's. I have tried using defferent tftp...
Unable to verify at the momment but I believe that is a single option, t1 or T1, comprised of the keyword followed by it's definition. If it were two options I believe they would be on seperate lines as such;t1 (description)T1 (description)
You may want to try the HP NNM forums at http://forums1.itrc.hp.com/service/forums/categoryhome.do?categoryId=162.You're likely to get a better reply as to how NNM handles NAT.bcbv
192.168.10.0/25 IS the subnet for which you are routing via RIP. The 192.168.10.128/25 subnet is NOT included in that route. This is where the static route comes into play.bcbv
The replacement was with a WIC-1DSU-T1 from a different distributor that Graybar uses. They told us that there were multiple complaints from customers that had bought the WIC from them that were received from one of their distributors.In light of the...
