Hi, I have configured two router R1 & R3 for ppp one way authentication. R3 calls into R1 for one way authentication however the serial interface does not seem to come up.Can u help me with this. I have attached the config too with the debug outputs....
Hi, Kindly put this into the Cisco error decoder and let me know what is the output because i don't have access to the decoder "Bad RAM at location 0xA0000000: wrote 0xA0000000, read 0xA0000200"Thanks,Ryel
I am having a issue with mpls label not getting assigned to vpnv4 routes. My lab setup is likeR6(CE) s1/3 ------à s1/3 R1 (PE) s1/2 -----------à s1/2 R3 (p) s1/3 ----------------à s1/3 R2 (p) s1/2-----à s1/1 R4 (PE) s1/2 --------à s1/2 R5 (CE).The v...
I would like to know which rpf rule in msdp will my following setup follow from the following•Rule 1: Applied when the sending MSDP peer is also an interior (M)BGP peer.•Rule 2: Applied when the sending MSDP peer is also an exterior (M)BGP peer.•Rule...
In MSDP is it required that the peering be done with another RP only ??? or supposing i have R1 in AS 100 (Being the Rp of that AS) has a MBGP peering with R2 in AS 200 (which is not the Rp on the AS). R3 which is behind R2 in AS 200 is the RP.for th...
Sorry for the late reply. The redistributed command did not help. Apart from that. It seems that labels are assigned in the cef tabel of R4 but they don't appear in the mpls for warding tabel. Kidly help me understand why ???R4#sh ip cef vrf ryel 6.6...
i have used the ip ospf network point-to-point on all the loopbacks and also have R1 using lo 0 (1.1.1.1) & R4 using lo 0 (4.4.4.4) for the router id in ospf and BGP. The bgp peering is also done on the two ip'sI still do not receives mpls label for...
It Seems my MSDP peering are up but some how multicast traffic traffic is not reaching R6 & yes there is a second link connecting from R3 s1/0 to R1 s1/0 for rpf check.R1 (sh ip msdp sum)Peer Address AS State Uptime/ Reset SA Peer N...