Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've an output by issueing show snmp group, could anybody tell me how to set notifyview value specific to my router and the benefit of setting notifyview? Thanks a lot!groupname: pubnot security model:v1rea...
Diagram: cisco2501A--CSS11150--Catalyst4006--Cisco2501BSyptoms:When I was trying to download image form Cisco2501B to Cisco2501B, a message displayed:Accessing file 'c2500-i-l.112-9' on 100.l1.1.1...Loading c2500-i-l.112-9 ... [timed out] [failed]The...
Thanks Jatin,The IP changed back to the original after I changed the IP to a new IP and then back to the original IP. However after a while, the IP changed back to 127.0.0.1. I did not know why. Maybe the primary host replicated data to the secondary...
The topology is as below:IP Phone 7940<-->2950<---trunk--->3750<---(IP networks)-->CallManagerIf I place the port under vlan 200, the phone works.There is no problem with DHCP. It seems there is something missing or wrong.
Have you checked your routing on both routers and made sure the central voice vlan and the remote vlan can talk to each other?I had one way voice problem a few weeks ago. The reason was that I did not have a route to remote voice VLAN althought the p...
Thank you for your reply. I try the following commands:interface FastEthernet0/2 description IP Phones&PCs switchport mode trunk no snmp trap link-status spanning-tree portfastendThe phone still picked up data vlan IP address.IP-Helper has been confi...
