Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone.We currently apply a config for one of our customers during pre-staging which requires us to apply SIM APN setting to cellular 0 profile 1 from enable. I believe this creates a profile of the 4G provider for the SIM card to use when co...
Hello there, I am reading up for the ECMS Certification.The linked article https://documentation.meraki.com/MR/MR_Splash_Page/Splash_Page_Details_for_Meraki_MR has the following note after describing the considerations of the click through splash pag...
Hi all,I am wondering why there is a choice for the two modes of operation on the MX appliance and what happens at the device level when I choose Passthrough over Routed mode. Is this the same as enabling or disabling Layer 3 functionality on a switc...
Hello all,We are acting as a pre-deployment staging centre for our client.We push a config down to C-1111 routers using the APIC-EM module accessed via a jump server on the customers’ network.C-1111 takes a config successfully, however does not hold ...
I am trying to set an AP from LW to Autonomous.I have managed to connect to the AP and used the command“debug capwap console cli” to gain access to exec mode and start a tftp image download.The AP interrupts the image download with messages that it c...
Thank you to every one that took time to reply, very much appreciated. I learnt something that I would not have understood otherwise.Marking @Philip D'Ath as the solution purely because anyone else reading this thread in the future will benefit from ...
Hey WW, thaks for the reply and taking time to post the links.I am currently working through the ECMS self study guide which also directed me to the same documentation.https://community.meraki.com/t5/FAQ-and-other-resources/ECMS-Exam-Self-study-Guide...
So its definately not the configuration register, I double checked this morning. As far as I can see running config is not being saved as startup config.Is this something APIC-EM should do or does the applied config require a write command after end?
Hi Torbjorn,Router is fresh out of the box so presume default of 0x2102. I will check in the morning jst to make sure and report back.Still interested as to how APIC applys a given config and if it requires the write command to be in the config file?
