Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a problem were replication from the primary ACS to the secondary ACS is failing. Yesterday morning, a scheduled replication worked just fine, but last night I attempted a manual "replicate now" and recieved the following error "Error (-16) t...
I have a proof of concept built for a client using wired 802.1x. We are using EAP-TLS with the MS Supplicant on XP SP2.Everything seems to work, with exception to unplugging the client and then replugging it back into the same port, which does not s...
I have numerous ASA5505s being managed by CSM 3.1 and would like to change the username and password that are used in the primary credentials (device properties). Is there a way that I can make this change in bulk, like in policy view or policy obje...
I have roughly numerous ASA5505s being managed by CSM 3.1 and would like to change the username and password in the primary credentials (device properties) is there a way that I can make this change in bulk, like a policy view or policy object manage...
I have CSM 3.1 up and running and am trying to get Performance Monitor running so we can monitor the VPNs. When I try to install it I keep get file ting the message:"One instance of CiscoWorks Installation is already running. If you are sure that n...
Settings are as follows:-Primary ACS->Network Conf->NDG AAA Svrs two entries itself with real ip and the secondary server with it's real ip, both with the same key-Primary ACS->Sys Conf->ACS Intern DB Rep -Rep Components(Send) - User n Group DB, Ne...
I am confused, we have this working just fine at the moment with the supplicantmode registry value at 2(the default for wired connections). I guess as long as the authmode is set to 2, it doesn't matter if the supplicant mode is set to 3.....before,...
Actually, it was a problem with the user cert. Once a profile was loaded on the box, and authentication had to happen again after unplugging the cable and then plugging it back in, the user cert. was requested for authentication and we did not have ...
I have used both Solsoft and CSM. In my opinion if CSM is set up correctly, utilizing shared policies, object overrides, etc. It is much more useful and easier to manage a large number of devices or a small number of devices with a large number of ...
