Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,My journey through VLAN hell continues, and I've progressed to the point where I've isolated things and realised I must be making some fundamental mistake. Can anyone give me any advice?Attached is my testing setup. Two switches connected by...
The plot thickens ... I've made progress and found that my core CSW switches were setup (not by me) with VLAN10 as the default VLAN, I of course went with the default and kept VLAN1.I followed the Cisco process from the commonly cited video guide to...
Hi,Ive had a fun few days trying to get this new iteration of dashboard up and running. I finally worked out why I can only have one directly manage device attached. Despite the standard configuration, using port 80 and port 443, when I try to regist...
Thanks guys, I've followed your instructions and gone with probe managed network.Only one Q - none of the devices show Connected in CBD Agent status? is that a direct only thing?Same as the SG switch till shows disconnected in status ?Cheers Paul
Hi Guys,Can I jump in - I've got 2 x SG250-08s and these won't connect to CBD giving an Unsupported error.Ive looked on Cisco's site https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/cisco-business-dashb...
Update - I got things working by changed from switcher General to Access, then once I realised that I went back to General but set the correct VLAN as the Access (untagged) and PVID then it works.I need to learn more about Access vs General.I was alw...
Just to add some more info .. the switch itself can't ping target on 192.168.10.45 .. see below from CLI I also added show ip routesDSW01#ping 192.168.10.45Pinging 192.168.10.45 with 18 bytes of data:PING: no reply from 192.168.10.45PING: timeoutPING...
