Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all.Been trying to make my internal phones to communicate to the PSTN line through a VIC2-2FXO card on my Cisco 2911 router.Problem is that in past tests, I managed to configure CME to direct PSTN call through an FXO card, but it was a differen...
Hello all.Sorry to barge in like this, since I am new around here, but I'm trying to implement a lab solution for CallManager 7 with a CallManager server, a VG202 and a router 2911.Besides the fact that CallManager itself it's like a tough cookie to ...
Ok Aaron,here's the deal.I got some logging going on on the router while i perform call tries.I keep getting this:*Mar 10 14:58:23.726: //12/80F2350A0A00/H323/cch323_determine_source_ip_group_info: No Source IP group match with Src CarrierId/Zone ID*...
Tried all that but still no luck.Configured the dial-peer on the router, i had already dial-peers, but I redone it.Also created the route pattern in ccm as you refered, but that does not go either.Do you have any other insight about this?Configuring ...
thank you again for your reply.seems that this new IOS 15 has alot of surprises.I'm having trouble installing SDM on this device. I keep getting a Not supported error when i try to install de 2.5.Without this, none of the Cisco graphical sotwares wor...
Thanks alfredosThat's a very good tip.Been checking the installed licenses on the 2911 router and I come up to this:Technology Package License Information for Module:'c2900'----------------------------------------------------------------Technology ...
