Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,First, I upgraded from 6.0.2.U6(6) to 6.0.2.U6(8). On success, I upgraded to 7.0.3.I7(9). The preparation went fine, with the switch reporting that the upgrade would be disruptive, and that "Power-seq upgrade needs a power-cycle".Last thing it ...
Hi,I had the idea of upgrading a 9951, which was happily talking to Asterisk, to version 9.3.2-10 from 9.2.3-27, in order to try get a fix for a few cosmetic issues. Now it won't register with Asterisk.The phone downloads its configuration file as us...
Good day,I have set up the files for an SPA502G (7.5.4) according to the excellent documentation at:https://supportforums.cisco.com/docs/DOC-9954However, the phone seems stuck in SPCP mode. When I factory reset it, it asks the TFTP server for SEPMAC....
Hi,I am using 7900, 8900 and 9900 series phones on a non-CM environment, totally unsupported, but working perfectly. A couple simple PHP scripts (sorry, IANAP) do the housekeeping and things are nice and tidy.Only one issue clouds the landscape, and ...
Good day,I want to isolate a voice network from the data and control planes by using a separate VRF. It all works perfectly except at one point: A router which has a PRI connected needs to send/receive voice traffic to/from a dial-peer which is in th...
Update: Swapping the eUSB module with a good switch had both switches booting, although the one with the "bad" module had to be booted manually from the boot loader the first boot.I am leaving this here for anybody with the same predicament: Just rem...
Note: Upon opening the unit seeking last chance salvage, we noticed that its storage is an eUSB module from Viking Technology. It can be trivially removed. After doing so and booting, the box goes to the boot loader. From there, it will be able to tf...
Unfortunately, since I can't get a bootloader prompt, it is not possible to try to boot through tftp. I have tried to get a bootloader prompt as described by pressing Ctrl-L but the switch won't offer any. I think that perhaps the switch has corrupte...
Thanks for your answer. I did; that is what I am talking about a cold boot. It is possible to reboot and run the switch without power cycling with a power sequencer firmware upgrade pending. I have done it many times. The only thing that happens in t...
