Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i hope anybody could give a usefuinformation about how i could apply a valid configuration on a cisco 1712 with a VLAN100 (joining two FE-ports, which is connected in two ways for incoming/outgoing traffic, transparently over the VLAN 100 interfa...
Hi Armand Arma,Do you simulating the "I'm running a lab with GNS3 which is composed of 2 ASA's (8.4.2)" in one GNS Instance.. Sorry for that question, if yes.. ! Could you describe how you done that "2 ASA´s" are running in "one GNS3 window" at same ...
Hi you can see additioanl to this information the following URL:http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_qanda_item09186a0080094cf4.shtmlhere is a case discussed with the following infos: Q. What does the error message "Lost ...
Hi Pengke11,would you think the etherchannel configuration would work.. ? I just looked at the technicial specification for the WIC-4ESW that we got here in the cisco 1712 (it does not support etherchannel). May be you look at the setup (attached to ...
