Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a Cisco 9200 where is connected my Cisco Access Point 3800 Series.The Access point is attached normally to the controller Cisco 5520 but the SSIDs are not shown arroudn the Access Point. I think that it is due to the fact that the switch...
Hello,i have created a route-map and i want to apply it on an interface PortChannel but the command is not working.It seems that there is no ip policy command.Note that i did the same command on another VDC and it works fine.Does i need to activate s...
Hello,I have a N7K which is configured with multiple VDC (VDC-DIST and VDC-CORE). i have EIGRP routing activated on the two VDC and the neighboring is working fine. I am also able to redistributed direct network connected from the DIST to the CORE. B...
Hello,I am configuring a Cisco router C1117-4PLTEEAWA for connecting to LTE network but the interface Cellular0/2/0 is not getting an IP Public Adress. Find attached the running-config and the profile created for it.Note that when i take the sim card...
Hello MHM,Sorry for late. Yes i tested it and it was good. I want to thank you for all the support you gave to me.It is really kind. Thank you very much.
