Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning community!We are migrating our offices to standard VLAN (2000-2009), 2000 is the management vlan where switches/APs etc have their IPs. It was going well until yesterday when we migrated one office (CKE) that has the same hop as SES (a ...
Hello team!I have 2 APs that got the same IP as other APs, thus they are not joining the WLC.I try to shutdown and power inline never the ports they connected on, to force them to reboot and get a new IP but they keep their old duplicate IPs. The lea...
Hello team!I have an issue and I can't figure out the solution. I'm sure it's stupid obvious but it doesn't come up in my brain.I'm setting up a new router with which I can currently ping internet and the GW ip from all vlans except vlan 5From the GW...
Hi Balaji,thanks for your quick reply.1. DHCP Server is located behind ICT RTR2. All the offices RTR can reach 10.70.254.254 and internet from any of the VLANs3. Here are the FHC, 2960X and SES RTR config. I do not have access to the ICT one as we do...
Hi Richard,you were right.. i'm missing the route for vlan 2008 in the router ospf table. So I added network 10.65.238.0 0.0.0.255 area 0.0.0.0 and now the ping is coming back to the new RTR.I thought that only one router could advertise the route in...
Of course, should have done that before, my bad.
Providing more background:
Previously, GW RTR was doing the routing for multiple building. I'm turning on routing on a switch in building xx so it is done locally.
That layer 3 switch is plugged into a...
