Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,I have started working on SD Access recently. Just curious about the failover mechanism here.I am sharing the design scenario which is standard for most of the designs. We have SD WAN for WAN connectivity and SD WAN is managed by another v...
Hi Experts,I am new to SD-Access solution. Is it a good practice to have stack of Border Node for a small site?I came across a post stating -it is not good to have BN stacked as you lose hitless SWIM for site (assuming u have single pair of BN & FN t...
Hi All,We have installed new WLC 9800 and new access points 9130 series. Tested all SSIDs successfully.In order to replace old WLC 3500, we updated IP address of new 9800 but when it came up, we can only see 2 tabs Dashboard and Monitoring on the lef...
We have established mobility between 9800 L C and AireOS model 3504. On 9800 WLC, I can see couple of client info shows AP name as 3504 WLC ip address. Does it mean mobility working as expected?How I can verify mobility is working fine?Thank you.
Hello, we can do it without shut down radios apI have 9800 WLC L C K9 and it has IOS image C9800-L-universalk9_wlc.17.03.03.SPA.binIn CLI, I used the command below and it fixed Wizard loop issue.WLC(config)# wireless country <Country_Code>Hope this w...
