About Mas627

Mas627 · 05-31-2023

Is there a way for the ASR9000 BNG to set the password for an IPoE session from the DHCP Option 82 remote-id?As far as I can see, the BNG sets the password. However, I have a situation where existing CPE's authenticating with RADIUS uses remote-id s...

Mas627 · 03-11-2023

I am testing EVPN Anycast on IOS XE. I have it working successfully, but when I enable OSPF between the CE, PE1 and PE2 the OSPF sessions constantly flap. Is this configuration not supported? I guess because the CE and PEs are in the same EVPN ins...

Mas627 · 09-25-2022

Is there any plans to release a version of XRv9000 that supports EVPN with bridge-domain and general Layer 2 protocol support? currently XRV9000 only supports EVPN VPWS and even that is limited. CSR1000v supports EVPN point to point and multipoint,...

Mas627 · 03-13-2023

Spoke to our Cisco partner, confirmed OSPF won't work but can use static routes and redistribute it to the rest of the network. Thanks again for the help.

Mas627 · 03-13-2023

The issue in my scenario I need routing between CE and PE, as the global routing table needs to learn CE subnets for internet access. not sure what you mean by data plane, it's just OSPF and BGP being used.

Mas627 · 03-13-2023

M02@rt37 @sidshas03 Unfortunately the issue still persists, after setting ospf interfaces P2MP OSPF still flaps. When I shutdown the link between CE1 and PE2, OSPF goes into FULL and stays stable. Maybe need to check with TAC on this?output from C...

Mas627 · 03-13-2023

M02@rt37 this is what I did with the intial configuration and seen OSPF adjancency flapping. I followed @sidshas03 configuring P2MP and this seems to have resolved the issue. I am doing more testing to make sure it's all okay. Thanks both for you...

Mas627 · 03-13-2023

But then how does CE1 establish an adjancency to PE1 and PE2? CE1 has interface address of 192.168.10.1 and PE have Anycast addres of 192.168.10.254. Moving the anycast address to a loopback means CE1 won’t be able to establish OSPF neighbour .

Member Since	‎09-25-2022 06:08 AM
Date Last Visited	‎05-31-2023 02:56 PM
Posts	9
Total Helpful Votes Received	1

User Statistics

User Activity

ASR9000 IPoE use dhcp remote-id as password

Enable OSPF between CE and PE using EVPN Anycast

XRv9000 evpn with bridge domain support

Re: Enable OSPF between CE and PE using EVPN Anycast

Re: Enable OSPF between CE and PE using EVPN Anycast

Re: Enable OSPF between CE and PE using EVPN Anycast

Re: Enable OSPF between CE and PE using EVPN Anycast

Re: Enable OSPF between CE and PE using EVPN Anycast