About gibsthomas

gibsthomas · 05-30-2006

Hey guys I'm seeing multiple routers connected to Frame-Relay in our network with DLCI 1007 active but unused. We never ordered this DLCI and have not assigned this to any sub-interface. But for multiple sites, its showing up as Active/ Unused under ...

gibsthomas · 05-19-2006

Hi..I would like to enable WoL feature in certain part of our network. Is there a global command to enable that?. or does it only require 'dot1x control-direction in' interface configuration?..Also does the WoL Magic packet get forwarded through rout...

gibsthomas · 05-15-2006

Hi, I cannot ping the e1 interace of a new PIX 525 running V6.35. I configured e1 address and tried but I cannot ping the laptop directly connected to it or viceversa.. added ACL to allowing icmp any any and IP any any and applied the e1 interface. ...

gibsthomas · 05-10-2006

Hi All,I have a PIX 525 on production with UR Licence running V6.3.4. I would like to put in a fail-over PIX. Fail-over PIX with FO License runs V6.3.5.. will there be any problems if the fail-over has a higher version than the Active PIX??.. I look...

gibsthomas · 02-15-2006

What command should I use to delete subinterfaces that are no longer required?Thanks,

gibsthomas · 05-19-2006

Thanks Guys.. i know what has to be done to make it work now.. will update once I configure it..Thanks,

gibsthomas · 05-19-2006

Hi Kevin,thanks for your reply. I might as well stay away from dot1x stuff.. have never used it but saw it on cisco site for WoL.. another question.. 1. I'll have clients at multiple locations/ subnet.. so do I have to enter ip helper broadcast addr...

gibsthomas · 05-15-2006

Hi, thanks for the reply. Active PIX is in production and runs IOS V6.3.4 and this fail-over pix is running V6.3.5. Will it cause any problems since the fail-over PIX has an upgraded version than the active PIX??

gibsthomas · 05-15-2006

Hi,this PIX is not in production yet and I wanted to upgrade the IOS image before putting this on production. I did wr erase on the PIX and reloaded it to see if it makes any difference. Also included icmp permit any any inside but I still cannot pin...

gibsthomas · 05-15-2006

I configured icmp permit any inside, icmp permit any echo inside & icmp permit any echo-reply inside but I still cannot ping the switch or mylaptop. pinging from my laptop to the pix also doesnot work. I can see the laptop IP on PIX when i do show ar...

Member Since	‎07-09-2005 04:32 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	37

User Statistics

User Activity

Frame Relay DLCI 1007 (Active / Unused) ??

Wake On Lan Feature - How to enable??

Cannot Ping PIX 525 inside interface

PIX 525 UR & FO License IOS Image

Delete Sub-Interfaces ?

Re: Wake On Lan Feature - How to enable??

Re: Wake On Lan Feature - How to enable??

Re: Cannot Ping PIX 525 inside interface

Re: Cannot Ping PIX 525 inside interface

Re: Cannot Ping PIX 525 inside interface