Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllWhen using ISAKMP profiles with vrf aware IPSEC is it possible to associate a ISAKMP profile to an ISAKMP policy? If, for example, two connections use the same ISAKMP encryption, hash and DF parameters, but ideally should use different lifetim...
Hi AllIs it possible to have router to router traffic encrypted (or host to router) when the routers are themselves the VPN endpoints - or is it only possible to encrypt traffic which passes through an IPSEC router? For example, I wish to ping a loo...
Hi AllMy PIX book states that for traffic to pass from a lower security level to a higher security level (e.g. Out i/f -> In i/f) then two requirements must be met:i) A static translation must exist for the destination.ii) An appropriate ACL/Conduit ...
Hi AllCan anyone provide a link to a document which details generic instructions for the 'hardening' of a router / switch config. I'm sure I've seen such a doc on the Cisco site previously, but have been unable to (re)locate it.Thanks in Advance.
Hi AllIs it possible to allow a telnet or ssh connection to a PIX via the outside interface? The documentation I have (seems to) state that telnet access via the outside interface 'requires' IPSEC - it is not made clear whether this is a recommendat...
^Thanks for the reply and useful link - appreciated.Whilst searching myself, I came up with this from the Cisco site:http://www.cisco.com/application/pdf/en/us/guest/products/ps6383/c2001/ccmigration_09186a008046c66d.pdfIt's has a lot of useful infor...