Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
foundamental question...ISL : support multi protocol like FDDI, TokenRIng, Ethernet,802.1q : support only Ethenet.whatelse could it be the differences between them?Thanks a lot
HiNeed to configure ACL for distribute-list :1. 100.100.x.0 150.1.1.1 10.1.1.1 1.1.1.1 subnets are advertised by peer router.2. permit less than x = 15 which is even like 14, 12, 10...3. permit 150.1.1.14. permit 1.1.1.15. permit 10.1.1.16. ...
Hello,when configure FR over PPP, what's different between with sub-interface and main-interface? any routing problem or L3 issues?1, # interface s0/0# frame-relay interface-dlci 100 ppp virtual-template 12.# interface s0/0.1 porint-to-point# frame-r...
Hellowhen configure a FR traffic shapping parameters,frame relay cir frame relay mincirframe relay bc.."During congestion, provider will mark any traffic in excess of ( ) as dsicard eligible"what is in the blank, cir or mincir?thanks
Hi Stefano,if I modify the neighbor X.X.X.X into neighbor X.X.X.X priority 0 on the Hub => you can't modify to "neighbor X.X.X.X priority 0" it's not showing up in the config, and they are the same neighbor X.X.X.X = neighbor X.X.X.X priority 0, I d...
Rick,I think i need to add more explaination. you are right Rick, but you are talking about "ip ospf priority".- neighbor IP priority 0 : priority of nieghbor- ip ospf priority : priority of itselfand with "neighbor IP priority 0" default is 0, and w...
with my understatnding,,priority 0 is default, so with your configuration, nothing to make any difference, because all routers have default priority 0. So after doing a DR election procedure R2 elected as DR. =========================================...
