Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts,I've got a cisco WS-C3750X-24 running C3750E-UNIVERSALK9-M (c3750e-universalk9-mz.122-58.SE2/c3750e-universalk9-mz.122-58.SE2.bin). I needed to limit the Bandwidth passed to a particular server on VLAN 30, but I was led to believe its n...
Hello there,I have a DMVPN with two spokes on an MPLS-L3-IPVPN network. IPSec over GRE using crypto Profiles. WOrks just fine. Now, the requirement is to only encrypt all traffic except DSCP-EF. Tried that using PBR by setting IP-Next Hop for EF-Pack...
Hello there,I have a DMVPN with two spokes on an MPLS-L3-IPVPN network. IPSec over GRE using crypto Profiles. WOrks just fine. Now, the requirement is to only encrypt all traffic except DSCP-EF. Tried that using PBR by setting IP-Next Hop for EF-Pack...
Hello ExpertsI've configured a DHCP Pool for a customer who wants the router to also give out a couple of dns suffixes to the clients.This is what I've done. Can you please advise how i can get it to work ?ip dhcp pool LAN import all network 10.1...
Hello ExpertsI'm writing to get some urgent help with Wireless on Cisco 1941W.The requirement is to have two subnets/VLANs/BVIs on the router (one for corporate access and another for Guest-Internet access. Both are to have wired and wireless clients...
Thank you Joseph ! It did need mls qos turning on and it did reset the ports like you said :). Sorted now but one question still. Is it not possible to do policing for egress traffic on SVIs instead , by using Policy-maps ?
Cheers
The PBR works fine, yes. On DMVPNs, is there any other ways of doing selective encryption, as crypto profiles don't do acls. If not, then I will stick with PBR.
Many thanks for your quick response.
Cheers
Hello,
Its not about preserving QoS markings across the tunnel i/f. The issue is that I cannot selectively encrypt traffic that goes across the tunnel because crypto profiles do not support ACLs.
So, I had to use PBR on the LAN i/f to direct all EF ...
Hi Rick,
Thank you for your reply ! PBR works fine. I am the service provider. I manage the CPE devices. No need for NAT as its just a VPN. DMVPN works fine too.
The issue is that I cannot selectively encrypt traffic that goes across the tunnel bec...
Hello Sir,Thank you for your reply. I read another thread about the 1941W wireless config and I think i may have sorted it out. The customer is yet to test it and get back to me but I think it should be pretty much ok. The platform specific thing tha...
