Hi Guys,I'm upgrading this chassis with a NPE400. I have read some documents which state a upgrade of the bootflash is required when I insert this new card.Am I right in assuming just installing the NPE card wont effect the config or IOS but may requ...

Telnet is enabled,yet it refuses conncetion and shows no active connections via the console.This is a 11051 chassis running 5.x software I believe. Console access works fine. Another interesting point is I can ping the box only once! then it fails af...

For the life of me, i cannot get my users to be able to create & edit subinterfaces using privilege levelsThis is my current privilege setupprivilege ip-vrf level 7 rdprivilege vpdn-group level 7 descriptionprivilege interface level 7 pvcprivilege in...

Hi GuysI have my SecureACS working well with Cisco devices, and have just completed a basic tacacs setup that works on my Juniper routers.I want to use the groups already defined in ACS to deploy permit/deny commands to for the Juniper routers - how ...

Guys, I'm hoping you can assist. I've defined a group for some level 2 engineers within ACS, however I want to be able to grant access for these guys to 'create' sub interfaces and have full control over those, but I do not want them to have control ...