Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, What exactly is the use for the command "ip dhcp snooping packets"? Do I need this? We had a problem today with users pulling a dhcp address. They were authenticating to the AP with no problems, but no luck pulling an address. FYI - these are con...
Hi, I have a site with three distinct departments that need to traverse two different PVCs on the same choked DS3. They teminate at a 3745 with 4 ethernet interfaces, dept. A (WIRE) uses f0/0 and f0/1 (one for backup) dept B (BRANCH) and C (IMAGE) us...
I read (can't find the document again) that you can run active/standby pix failover set on two different versions as long as the first two digits matched up - i.e. 7.0.1 and 7.0.4. I upgraded my secondary pix515 to 7.0.4 and want to wait until at lea...
In this document:http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080093f85.shtmlThere is an IOS config note that says:"IOS Configuration Note: With Cisco IOS Software Release 12.2(13)T and later codes (higher numb...
Hi, I am trying to create an vlan interface on a 2691 router but can't do it. What switch module do I need and what code. Argh!! I've searcehed all over cisco but I can't find it. What am I mmissing??Thanks,Lee
Thanks! It looks like since our DHCP servers do not support option 82, the "no ip dhcp snooping information option" command needed to be implemented globally. Things are working now. The TAC case can be read about here - http://www.ciscotaccc.com/kai...
Rick, Thanks for your input. I'll have to test this out in my lab today. I have many tunnels in production network that have in fact the crytpo map command on both physical and tunnel interfaces. We'll see how it goes. Lee
This is my show ver:Cisco Internetwork Operating System SoftwareIOS (tm) 2600 Software (C2691-ADVENTERPRISEK9-M), Version 12.3(15a), RELEASE SOFTWARE (fc2)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2005 by cisco Systems, In...
GP, Thanks!!I am running (C2691-ADVENTERPRISEK9-M), Version 12.3(15a) on a 2691. Thanks. I assume I need a switching module, but I'm not sure how I get it, or what it is. Thanks,Lee
