Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Paul, Can you please check if you have installed the flash player for IE. You could un-install the flash player and download the one for Internet Explorer. Let me know if you still have problems after installing the right flash Player.
Hi Joe, Please pickup the latest CCP version (v2.5 posted on 29th June 2011). Let me know if the problem is resolved. CCP supports configuration of single helper address. If multiple addresses are configured, then they are read in, but shall not be...
Hi, You could use the Cisco Configuration Professional GUI to configure dhcp pool and static binding as well. Navigate to Configure > Router > DHCP > DHCP PoolsConfigure > Router > DHCP > DHCP Bindings Let me know if this helps. Thanks,Chaitra
Hi Andrew, If you are trying to configure secondary IP addresses on the interface, Cisco Configuration Professional does not support it yet. You could use the following CLI to configureRouter#conf tEnter configuration commands, one per line. End wi...
Hi Andrew, Please use the screen Security -> Port to Application Mapping to create a port map. Once you create an entry in this screen, you could use it in the Zone Based Firewall screen.Let me know if this helps.ThanksChaitra
