Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi John, For the FCIP link it is just an IP connectivity. So, you can do in both ways as you describe. You can route it or use a vlan. Just make sure that you have no too hign RTT. And also there RTT timout setting on FCIP you can play with that acc...
Hi Stephen, Unfortunately, no, it is not possible to get more than 2 Gbps tx/rx rate on that module. There are 4 Gbps modules, you can achieve this with those modules ( 12/24/48 ports). http://www.cisco.com/en/US/partner/products/ps6781/index.htmlReg...
Hi, Here is the command to change the area id;conf tfcdomain fcid databasevsan 10 wwn 33:e8:00:05:30:00:16:df fcid 0x070128For details, you may want to check out the following URL:http://www.cisco.com/univercd/cc/td/doc/product/sn5000/mds9000/1_3_1/s...
Hi, Unfortunately it is very difficult to suggest you any device or solution to build your SAN, since we don't know exact the requirements of your business. I would suggest you to consult this with your local cisco office ( your account manager ) and...
Hi, Here are some design guides :http://www.cisco.com/en/US/partner/netsol/ns340/ns394/ns259/networking_solutions_design_guidances_list.htmlhttp://www.cisco.com/en/US/partner/netsol/ns340/ns394/ns259/networking_solutions_packages_list.htmlIn which ar...
