Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have interesting question as i am fighting with this for past few days. Topology is as followingSITE1 - EDGE_SITE1 - ISP - EDGE_SITE2 - SITE2Site 2 want all their traffic NAT'ed and send it over the Site-to-Site VPN (IKEv1)So for Site 1 conf...
Hello, We had upgrade to A5 3.0 and reload device device has lost all its configuration, after that we downgraded to same version as primary A5 1.2 and add back basic config, once we enable FT groups devices going thre sync process and displays below...
Hello, I am studying PIM Sparse mode and start working on AutoRP. I have a small topology consist of 6 routers which are connected over FrameRelay point to point. I have tested this topology using static RP assignments and is working as expected. No...
Hello,Working on the simulation to show how BGP network x.x.x.x backdoor is working. So in the below example i have router which is configured with backdoor, when IGP (OSPF) is running i see this route in routing table, but from curiosity i shut that...
Hello, I know it is already a lot of topics related to redirects but i was not able to find something related to my issue. I have three sites: www.test.com -- main site which already has redirection between http-https www.tests.net -- blank site www....
I tried but i get the following message: EDGE_SITE2(config)# ip nat pool INT 30.30.30.2 30.30.30.2 netmask 255.255.255.254%Pool INT mask 255.255.255.254 too small; should be at least 255.255.255.252 Also interesting when i had static nat ip nat insid...
What i mean about missing something is regarding nat statement.As i mention in my previous post the static nat that you suggested to set up for bi-directional traffic works as longest the VPN is established by other means (ex: Site 1 initiate traffic...
Hello, Marius, thanks a lot i did change from dynamic nat to static and it worked but in a wired way. So when i have established VPN session and add that static nat it works. My screen scraping: EDGE_SITE2(config)#do sh crypto isakmp saIPv4 Crypto...
.JPG "bkohli_2"){kind=avatar}