Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a stack of two Catalyst 9300X switches running in a stack, with Meraki firmware.Does anyone know what is the OID to get the modules and serial numbers of the 2 members ? I get information about the one acting as the master and some inform...
hello,Is there a display showing the interface connectivity between a switch and a firewall, both are MERAKI product ?I don't find where is the display about CDP/LLDP information.a switch is connected to a firewall port, but I don't know which inter...
Hello,To have a management tool polling by SNMP some information like CPU load and memory load, I tried to find out the OID.The supervisory card is a WS-X45-SUP7-E with a dual core CPU and 2G of memory.IOS is IOS-XE 3.2.2sh proc cpu Cor...
Hello,A customer wants to get the backplane load of a cat4506-e chassis with a sup6-E supervisory card.A would like to check how many bus are used on the backplane and if the command "sh envi chassis" is the good and only command to be used ?I'm not ...
Hello Philip DAth,Very good suggestion.Unfortunaly, on my site, the FW IP's addresses neither its MAC address are found with a network wide > client > display. Maybe because the FW release or I don't look for the good IP address (I used the one to m...
Hello ByronC,ok thank you.Temporary activation for a short time CDP/LLDP would be great. I understand that it is not by default for security reason.Regards,Jean-David
