Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We upgrade our ASA(Active / Standby) firewall from 9.2(2)4 to 9.12.4 Interim last night. Upgrade Activity is fine. But, after upgrade to 9.12.4, our anyconnect user can't connect. And we got this error message -
Security Warning: Untrusted Server ...
We want to by a wireless hardware controller(C9800-L) for our Access Point Management as a primary controller.
We also need a backup WLC. Therefore, we want to deploy Cisco WLCv 9800-CL on our Esxi. (NOTE: this will cause our budget)
is it ok to depl...
Dear @Rob Ingram ,
i would like to provide the following information.
if you need any other information, pls let me know, i will provide you.
Best RegardsAung Ye
hello @Rob Ingram ,
which command that i use to take ssl vpn configuration.
please tell me, i want to provide the configuration for review.
Bets RegardsAung Ye
Dear @Rob Ingram ,
i configured the certificate and trust point. user credential prompt and then i got this error message. please suggest me.
best regards
aung ye khant
Dear balaji.bandi,
all user can't connect anyconnect. how to check ASA side logs. i enable "debug ssl 255" command but result is nothing.
Certificate check on ASA.
Could you please guide me to solve this issue?
Best Regards
Aung Ye
