Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Pavel,Yes, we do have a API flavor for service configuration. You can refer to Programming Guide section under SCA BB.http://www.cisco.com/en/US/products/ps6135/products_programming_reference_guides_list.htmlFor applying/retriving the service conf...
Hi Jaime,We had tested the workaorund before suggesting it. As 3.7.2 is recently released, it could be possible that we are missiing some scenario. This would require further troubleshooting. So, I would suggest you to open a service request, and we ...
Hi Gurcan,Thanks for sharing the defect ID.Hi Jaime,The issue you are facing is tracked by the defect mentioned. As a workaround we would suggest you to run the following command after any changes to the CLI or applying service configuration. This wo...
Hi Gurcan,Opening service request is the way to reach TAC. Once the service request is raised, TAC engineer would perfom the investigation of the support file, and recommend on the diagnostics part, if required.Cisco Technical Support site:http://www...
Hi Jamie,You had mentioned that the reports are one hour out of sync, so it looks like its related to daylight savings. In CM, you would have configured the SCE Offset. Check if the value is correct. The SCA Reporter does not use the correct time int...
