Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We are going to do an upgrade on some asr9k´s from 4.0.1 to 4.2.3. Current IOS-XR software is installed in disk0, so my question is if it´s possible to install the new software packages (pies and SMUs) in disk1 and then to select this one to bo...
Hi all,I was trying to configure the track interface command within hsrp, and when I apply the command the priority group decrement immediately.Before of apply the configuration:RP/0/RSP0/CPU0:PE1-ASR9010-LAB-MACUL#sh hsrp bvi 600Thu Sep 12 14:04:07....
Hi All,I have to install transceivers ER in one ASR9010 and I have available two types: XFP-10GER-192IR+ and XFP10GER-192IR-L. I saw the compatibility matrix document and it says that I can use both types in one 8X10G Linecard. So my question is what...
Is it neccesary some specific traps for RSP switchover?.We are doing HA tests but when we did the switchover we didn´t see the alarm in monitoring system. We were able to see all the rest of alarm, for example LC OIR, interface up/down, power modules...
No. That´s why I am asking why the priority decrement if the interface is always UP.Look:RP/0/RSP0/CPU0:PE1-ASR9010-LAB-MACUL#sh inter gi 0/3/0/26Fri Sep 13 10:41:55.907 UTCGigabitEthernet0/3/0/26 is up, line protocol is up Without track command:RP/0...
Hi Ashish,Good document. But I have a question, If I want to track some interface the only way to do that is with track object command?.I ask this because I was trying to configure that with track interface command and when I apply the command the pr...
Thanks Xander.And regarding dwdm XFPs, has CRS a restriction about the number of modules inserted in a slot?.We have a 14x10GE PLIM with 4 dwdm xpf ( ports 0,2,4 and 6) and 2 LR xpf (ports 3 and 10). Now we want to install more dwdm and LR XPFs. Is t...
