Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I need to configure a new ACS SE, model 1113, but has problem in configuring proper ip address in first attempt. I tried to use the set ip command to change it but it didn't work. Then I performed the setup again by rebooting the machine and p...
Hi All,We have two routers configured with HSRP and support NAT static mapping. We would like to change HSRP to GLBP. But I can't find any information regarding NAT static mapping support with GLBP. Is it possible to retain the "redundancy HSRP" if G...
Hi All,We have a NAS (AS5350) to provide dialup service for branch offices. Cisco ACS 4.0 (Radius) is used as the AAA sever. We would like to apply acl to the dialup client to control the access by using filter-id attribute. The acl can be applied an...
Hi Gagan,I was able to test the configuration today and captured the output for your reference.The following command "aaa authorization exec default group radius local" was added before capturing the output.It seemed that if the acl is applied in inb...
Hi Gagan,Sure, the running configure and screen caputer of the filter-id attribute are in the attachment.I tried to configure the Cisco av-pair attribute for testing purpose but they had been removed.With Best Regards,Anthony
Hi Gagan,Exactly, we choose the 1st method in order to be compatible with old configuration. The access-lists are defined in the NAS and the attribute filter-id is passed to it when dialup client is successfully connected. I only have previous output...
