Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,I have started to learn BGP. While failover scenario not working.Working scenario When trying to ping PC-1 to PC-2 its reachable. Non- Working scenario when i shutdown the interface R3 to R1. Not reachable PC-1 to PC-2. -------------------------...
HI ,i have ASR-1009-X and C9K both connected OSPF and LAN segment L3 in C9K.ASR and C9K both in OSPF and LAN segment advertise in OSPF. when i taking ssh through p2p interface IP both device access from my LAN. Requirement is ssh should happen throu...
Hi,I have vrf PROD_VRF this vrf having vZany contract(consumer and provider common tenant). Same vrf using L3out , BD have EPG.In L3out EPG have subnet - 10.0.0.0/8. This subnet host can access form EGP host with any L3 out EPG.BD name- PROD_BD / BD ...
Hello,
Pease find the below lab configuration.
R1 and R2 same AS . R3 and R4 is different AS.
i have advertise the two network
(6.6.6.6/32 & 7.7.7.7/32)
Both the network im able to ping R2 and R3. But not able to ping R4.
R4 both neighbor establish s...
Hi,below topology sw1 to sw2 connected interface sw1 end interface showing errr disable. both end port access port. Sw1 infoSwitch#sh int statusPort Name Status Vlan Duplex Speed TypeFa0/1 connected 111 auto auto 10/100BaseTXFa1/1 err-disabled 111 au...
in vty i used standard ACL only source only defined.As per my understand for this case extended ACL will play role..... Is there is any way specific source to destination permit in standard ACL.
Hi,
6.6.6.6 and 7.7.7.7
both network locally originated in R1.
i have advertised in BGP using network command.
in R4 both network are learning but not able to ping.
i want to know why its not able to ping
