Any ideas? After clearing arp, it wents ok, but how to solve this without clearing manualy?
interface Vlan2
ip address 10.101.1.1 255.255.255.0
arp timeout 180
end
DSA#show mac address-table aging-time vlan 2Global Aging Time: 300Vlan Aging T...
Hello,I have encountered such problem, that everything works, until I do the following:route-map TEST permit 10!ip vrf lt import ipv4 unicast map TEST!After few seconds:ip vrf lt no import ipv4 unicast map TESTAfter these changes I don't see vrf srv ...
Hey,I have C3560 and encoutered with such issue, that it doesn't mark packets I want. Configuration:int vlan 100 ... service-policy input REDIRECT!class-map match-all HTTP match access-group name ACL_HTTP!policy-map REDIRECT class HTTP set dscp 63!i...
Hello,how to route between vrf interface and non vrf interface? BGP is active on non vrf interface, OSPF on vrf interface. Need that LAN, which is under "vrf local" should be able to reach outside network (non vrf) and vice versa. Please be free to a...
Hello,I have two VRFs: global and local. R2#sh ip route vrf global | begin GatewayGateway of last resort is not set 100.0.0.0/24 is subnetted, 1 subnetsB 100.100.100.0 [20/0] via 20.0.0.2, 00:50:48 20.0.0.0/30 is subnetted, 1 subnetsC ...
Hey, tried everything in this case. Everyhing wents OK after removing switchport block unicast from that interface, which has the mac. Maybe the switchport block unicast should be applied on access instead of trunk?Donatas.
One more output of debug:R1(config-vrf)#import ipv4 unicast map LTR1(config-vrf)#*Mar 1 00:02:28.087: RT(lt): del 30.0.0.0/30 via 0.0.0.0, bgp metric [20/0]*Mar 1 00:02:28.091: RT(lt): delete subnet route to 30.0.0.0/30*Mar 1 00:02:28.095: RT(lt):...