Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Is there a image available for xrd-control-plane-container-x86.26.1.1.tgz for lab purposes? Without SN or PO. I am testing multi-vendor AI fabric with NVIDIA Spectrum X and Cisco.Thank You.
Hello,We have a situation where FXO ports are connected to DMS-10 at telco end. DMS-10 doesn't send out any disconnect tone or power denial. Is there a way to detect on CISCO ISR that remote party has disconnected call? Is there a way to disconnec...
Hello,Is there a way to disconnect call on CUCME 8.6 if call was on hold for certain amount of time. We had situation where someone place call on hold and call wasn't ended on either side, and music on hold was going on all night. Thank You in advan...
Here is my final config....voice class dualtone-detect-params 1 freq-max-deviation 50voice class custom-cptone DISC_CAN dualtone disconnect frequency 480 620 cadence 500 500 voice-port 0/0/0supervisory disconnect dualtone mid-call supervisory dualt...
Thank you for your reply...I tried to test that but still no change. I captured pcm.dat file and see there is disconnect tone coming from Telco, there is a silence on line for a few sec. I can't seem to find a work around.....
AA script on CUE..below is configuration of Dial-peer pointing to CUE AA pilot. Seems like RTCP is still active one way from CUE AA to user but not in other direction, so it never kicks RTCP media-inactive command. dial-peer voice 201 voip descript...
Hello Thank you for relpy...I have tried this and doesn't work. When remote end hangs up after hearing AA, call doesn't get cut off and AA trasfers call to hunt-group as it doesn't detect any input from user. If no one picks up on hunt-group it goe...
